I wanted a quick box for Vale this weekend so I knocked this up from 6mm poplar, the joints are all a little bit tight and I have a weird feeling my laser isn't cutting vertically again. I wanted the lid to be secure so I put two more hinge points onto the lid. I'll gloss over the inscriptions as its too complicated to explain :) (svg here)
Thursday, 12 May 2016
Wednesday, 11 May 2016
Dominic has been a fan of these assembly brackets for some time now, he even went as far as making a set and posting them onto thingiverse. I had to glue some wood sheets at right angles to each other and these seemed to be the right thing for the job so I cut myself a set too and glued everything appropriately. Pretty useful but mine were only 6mm thick to tended to flick themselves flat until I got the second clamp into place.
Tuesday, 10 May 2016
The program ended up being a bit of a mess as it evolved throughout the course of the weekend. It's got some nice features though such as the ability to capture or load an image for engraving, automatic detection of GRBL devices on the serial ports and free text sending to control GRBL directly. I've attached the code here should you want to achieve something similar (Source code)
One good thing that did come from the code was a simple program to save and load GRBL settings to a controller or a text file. I managed to overwrite my settings by accident and this program allows me to save them all in a text file and then send them to the controller in a few clicks, similar things probably exist elsewhere but this is my version. (Source and Executable)
Below the cut is a veritable rogues gallery of all the artwork that was done over the two days